F900R / F900XR - (2019 >)

 

 Product Compatibility

  • vSystem
  • xSystem
  • eSystem
  • REP Connect + Hex ezCAN K1600
  • Traveller Expansion Bag
  • Scorpion Dual Injector
 
  • Magnum HCR

 

 

 

 
  1. Go to vSystem Installation
  2. Go to xSystem Installation
  3. Go to eSystem Installation
 
 

vSystem Installation

Step 1 - Find a vacuum source 

There is a vacuum pipe from the inlet tract to the EVAP system. You can read more about the EVAP System and identifying the correct vacuum pipe here. Cut this pipe and insert the 6mm Tee connector. Push the vacuum damper onto the third leg of the Tee connector.

 
 
 
 
 
 

 Step 2 - Find a place for the reservoir 

The reservoir can be mounted under the seat or on a frame spar. Ensure that the top of the reservoir is at least slightly raised (ideally above 15° from horizontal) to maximise the available range.

 
  Micro RMV shown.
 
 
 Standard RMV shown.
 
 

Step 3 - Mount the dispenser and connect the system

 
 
 
 

Step 4 - Fill, prime and set up your vSystem

Once fitted, fill and prime the system and set the adjuster knob to ’prime’. Start the engine and turn the adjuster knob until a flow of between 1 and 2 drops per minute is achieved. Check the condition of your chain after a ride, and then adjust as required.  

For best results clean your chain before fitting the Scottoiler using paraffin or similar. Then lightly oil the chain from the bottle using a rag or a brush, this allows the oil from the Scottoiler to reach both sides of the chain. 1 to 2 drops per minute will maintain this film of oil on the chain.

 

 

 

 

xSystem Installation

General xSystem guide

The xSystem chain oiler is really easy to install and can be mounted on your bike in less than 1 hour. The installation consists of the three simple steps:

  • Find a place for the reservoir
  • Connect the xSystem wiring harness directly to your battery
  • Route the dispenser to your rear sprocket

For an example of the installation see our xSystem Installation guide. 

If you have our system installed on this specific motorcycle model, we would appreciate if you could send us pictures. With more pictures we can make the Installation even easier for all motorcyclists. Please send us your feedback and photos to technical@scottoiler.com. 

 

 

 

 

 xSystem location suggestion.

 

 

Route Delivery Tubing

 

    

 

 

 

 

 

 

 Scorpion Dual Injector

 

      

 

 

 

 

 

eSystem Installation

 

General eSystem guide

The eSystem chain oiler is really easy to install and can be mounted on your bike in less than 1 hour. The installation consists of the three simple steps:

  • Mount the display on your handlebars
  • Connect the display and reservoir to your battery
  • Attach the dispenser and route the delivery tubing to the reservoir

For an example of the installation see our eSystem v3.1 Fitting Instructions. 

If you have our system installed on this specific motorcycle model, we would appreciate if you could send us pictures. With more pictures we can make the Installation even easier for all motorcyclists. Please send us your feedback and photos to technical@scottoiler.com. 

 

 

Note; when positioning the reservoir make sure there is enough space left for suspension movement.

 

 

Article Number: 575
Author: Oct 14, 2020
Last Updated: Oct 31, 2025

Online URL: https://marketingengineer.de/article/f900r-f900xr-2019->-575.html