Enter your motorcycle make and model to learn more about how to install a Scottoiler chain oiler system on your bike:

Meteor 350 (2020 - ...)

 Product Compatibility

  • vSystem
  • xSystem
  • eSystem
  • Traveller Expansion Bag
  • Magnum HCR
We are always looking for photos of your installation to improve our guides, if you would like to share the setup on your bike please send your installation pics to technical@scottoiler.com.
  • Scorpion Dual Injector


  1. Go to vSystem Installation
  2. Go to xSystem Installation
  3. Go to eSystem Installation 


vSystem Installation

Step 1 - Find a vacuum source 

The first step is to find the vacuum connection on your bike. This could be an already existing and blanked off vacuum spigot, a vacuum blanking screw, a vacuum operated fuel tap or a balancing pipe between your cylinders. Motorbikes after 2016 also have an EVAP System to control the emissions. This is operated by the engine vacuum and you can connect into the vacuum line between the throttle bodies and purge valve. Once you have identified your vacuum source connect it with the vacuum damper elbow and black vacuum line to your Scottoiler. 







Step 2 - Find a place for the reservoir 






Step 3 - Mount the dispenser and connect the system





Step 4 - Fill, prime and set up your vSystem

Once fitted, fill and prime the system and set the adjuster knob to ’prime’. Start the engine and turn the adjuster knob until a flow of between 1 and 2 drops per minute is achieved. Check the condition of your chain after a ride, and then adjust as required.  

For best results clean your chain before fitting the Scottoiler using paraffin or similar. Then lightly oil the chain from the bottle using a rag or a brush, this allows the oil from the Scottoiler to reach both sides of the chain. 1 to 2 drops per minute will maintain this film of oil on the chain.




xSystem Installation


General xSystem guide

The xSystem chain oiler is really easy to install and can be mounted on your bike is less than 1 hour. The installation consists of three simple steps:

  • Find a place for the reservoir, either on the frame or under the seat
  • Connect the reservoir to your battery
  • Route the dispenser to your rear sprocket

For an example of the installation see our xSystem Installation Guide

If you have our System installed on this specific motorcycle model, we would appreciate if you could send us pictures. With more pictures we can make the installation even easier for all motorcyclists. Please send us your feedback and photos to technical@scottoiler.com


 eSystem Installation


Customer Installation

Please see below for a detailed eSystem installation by one of our customers. You can also download an accompanying PDF here. 

    There are no attachments for this article.